Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| 3dprinters:d7:start [2024/12/01 21:31] – John Harrison | 3dprinters:d7:start [2024/12/03 18:08] (current) – John Harrison | ||
|---|---|---|---|
| Line 44: | Line 44: | ||
| * use ultrasonic cleaner at least 10 min | * use ultrasonic cleaner at least 10 min | ||
| * you can sand the build surface of the platform | * you can sand the build surface of the platform | ||
| + | * [[https:// | ||
| + | * a heater in the enclosure is a good idea. One particular model measures 2.26x1.26x4.25 | ||
| + | |||
| + | ==== supports ==== | ||
| + | * change raft area ratio to 150% | ||
| + | * raise object by 5mm | ||
| + | * clean then remove supports then clean again then cure | ||
| + | * can fill ultrasonic with water then put in a plastic cup to save IPA | ||
| + | * when removing supports soak first in hot water 130 to 150*F | ||
| ===== Next Steps ===== | ===== Next Steps ===== | ||