Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| 3dprinters:ender3pro:start [2025/01/29 19:47] – John Harrison | 3dprinters:ender3pro:start [2025/12/14 20:25] (current) – John Harrison | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| * speed 25 | * speed 25 | ||
| * cooling fan 100% | * cooling fan 100% | ||
| + | |||
| + | ===== 2 color printing ===== | ||
| + | ==== Cura ==== | ||
| + | * post processing scripts --> pause at height | ||
| + | * Pause at the layer **before** where you want to color to change i.e. the last layer before you want to switch filaments | ||
| + | * it should be worded as pause *after* layer | ||
| + | * example: if new color starts at layer 6 pause at layer 5 | ||
| + | * park print head X and Y both to 0 | ||
| + | * set retraction to 0 | ||
| + | * set standby temp to printing temp | ||
| + | * method: Marlin (M0) | ||
| + | * when the printer pauses | ||
| + | * remove old color and set new color in | ||
| + | * manually push the filament through the nozzle until the new color shows up | ||
| + | * ever so slightly pull back the filament (manual retract) so the new color doesn' | ||
| + | * clean the nozzle | ||
| + | * click the knob on the printer to resume the print | ||