| Both sides previous revision Previous revision Next revision | Previous revision |
| car_auto:corolla [2025/05/09 06:54] – John Harrison | car_auto:corolla [2025/05/09 06:56] (current) – John Harrison |
|---|
| ===== 2019 Corolla ===== | ===== 2019 Corolla ===== |
| ==== CVT Transmission Service ==== | ==== CVT Transmission Service ==== |
| | //to be done every 60K miles?// |
| * Fill Plug washer/gasket part #: 90430-18008 | * Fill Plug washer/gasket part #: 90430-18008 |
| * CVT Drain Plug washer/gasket part #: 90430-12008 | * CVT Drain Plug washer/gasket part #: 90430-12008 |
| * {{ :car_auto:tis_-_toyota_2014-2019_corolla_repair_manual_rm30n0u_fluid_level_check.pdf |Official Service Procedure from Toyota}} | * {{ :car_auto:tis_-_toyota_2014-2019_corolla_repair_manual_rm30n0u_fluid_level_check.pdf |Official Service Procedure from Toyota}} |
| * [[https://www.youtube.com/watch?v=eRxSu4-4ojo|video from Car Care Nut (Toyota technician)]] | * [[https://www.youtube.com/watch?v=eRxSu4-4ojo|video from Car Care Nut (Toyota technician)]] |
| === Getting the correct temp ==== | === Getting the correct temp === |
| 1. jumper between pins 4 and 13 of OBD2 | - jumper between pins 4 and 13 of OBD2 |
| 1. start car. | - start car. |
| 1. P, R, D, R, D a few times | - P, R, D, R, D a few times |
| 1. N, D over and over until D sticks (N doesn't show) | - N, D over and over until D sticks (N doesn't show) |
| 1. Shift to park. Keep engine running throughout | - Shift to park. Keep engine running throughout |
| 1. Disconnect jumper pins (important or idle speed might be incorrect) | - Disconnect jumper pins (important or idle speed might be incorrect) |
| 1. While in Park, look at dash shift indicator correct temperature | - While in Park, look at dash shift indicator for correct temperature |
| 1. If no gear shown (it's blank), temp too low. Wait | - If no gear shown (it's blank), temp too low. Wait |
| 1. If D is solid, temp correct. Drain excess fluid | - If D is solid, temp correct. Drain excess fluid |
| 1. If D blinking, temp too hot. Shut off engine, let cool down, try again. | - If D blinking, temp too hot. Shut off engine, let cool down, try again. |
| |