Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| lwc:hardware:ciscoaironet1130 [2021/02/13 06:46] – John Harrison | lwc:hardware:ciscoaironet1130 [2021/03/16 14:48] (current) – John Harrison | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== General Information ===== | ===== General Information ===== | ||
| * serial port is 9600 baud | * serial port is 9600 baud | ||
| - | * to turn something off, put a `no` in front of the configuration | + | * to turn something off, put a '' |
| - | * to see current configuration | + | * to see current configuration |
| * you can cut/past multiple commands/ | * you can cut/past multiple commands/ | ||
| - | * see current virtual lans: `show vlan` | + | * see current virtual lans: '' |
| - | * fastethernet abbreviation is `fa` | + | * fastethernet abbreviation is '' |
| + | * change hostname: '' | ||
| + | * '' | ||
| + | * set the channel only with physical Radio0 and not the " | ||
| * vlans appear to be intended to be used only with Cisco switchports and perhaps when they are in trunk mode | * vlans appear to be intended to be used only with Cisco switchports and perhaps when they are in trunk mode | ||
| - | * it appears [[https:// | + | * it appears [[https:// |
| < | < | ||
| router(config)# | router(config)# | ||
| Line 13: | Line 16: | ||
| router(config-subif)# | router(config-subif)# | ||
| </ | </ | ||
| - | * 8266 with Arduino Wi-Fi library seem happiest with `encryption mode ciphers aes-ccm` | + | * 8266 with Arduino Wi-Fi library seem happiest with '' |
| - | + | ||
| - | ==== Unanswered Questions ==== | + | |
| - | * do we set the channel only with Radio0 or all the " | + | |
| - | * do all the ssids have to be on the same channel (guessing yes) | + | |
| ==== Multiple SSIDs example ==== | ==== Multiple SSIDs example ==== | ||
| Line 32: | Line 31: | ||
| int dot11radio0 | int dot11radio0 | ||
| mbssid | mbssid | ||
| + | !channel 2412 | ||
| + | !channel 2437 | ||
| + | channel 2462 | ||
| encryption vlan 2 mode ciphers aes-ccm tkip | encryption vlan 2 mode ciphers aes-ccm tkip | ||
| - | ! encryption mode ciphers aes-ccm | + | ! encryption |
| ssid LAB2 | ssid LAB2 | ||
| no shut | no shut | ||
| Line 42: | Line 44: | ||
| int fa0.2 | int fa0.2 | ||
| encapsulation dot1Q 2 native | encapsulation dot1Q 2 native | ||
| + | exit | ||
| exit | exit | ||
| ! -------------------- | ! -------------------- | ||
| Line 56: | Line 59: | ||
| mbssid | mbssid | ||
| ! encryption vlan 3 mode ciphers aes-ccm tkip | ! encryption vlan 3 mode ciphers aes-ccm tkip | ||
| - | encryption mode ciphers aes-ccm | + | encryption |
| - | ssid LAB4 | + | ssid LAB3 |
| no shut | no shut | ||
| exit | exit | ||
| Line 66: | Line 69: | ||
| int fa0.3 | int fa0.3 | ||
| encapsulation dot1Q 3 | encapsulation dot1Q 3 | ||
| + | exit | ||
| exit | exit | ||
| ! -------------------- | ! -------------------- | ||
| Line 80: | Line 84: | ||
| mbssid | mbssid | ||
| ! encryption vlan 4 mode ciphers aes-ccm tkip | ! encryption vlan 4 mode ciphers aes-ccm tkip | ||
| - | encryption mode ciphers aes-ccm | + | encryption |
| ssid LAB4 | ssid LAB4 | ||
| no shut | no shut | ||
| Line 91: | Line 95: | ||
| encapsulation dot1Q 4 | encapsulation dot1Q 4 | ||
| exit | exit | ||
| + | exit | ||
| + | copy run start | ||
| </ | </ | ||
| - | note: see comment about vlans and switchports above. That configuration for the fastethernet *may* be required | + | note: see comment about vlans and switchports above. That configuration for the fastethernet |
| ==== References ==== | ==== References ==== | ||