This is an old revision of the document!
General Information
- serial port is 9600 baud
- to turn something off, put a `no` in front of the configuration
- to see current configuration `show configuration`
- you can cut/past multiple commands/settings as once
- see current virtual lans: `show vlan`
- fastethernet abbreviation is `fa`
- vlans appear to be intended to be used only with Cisco switchports and perhaps when they are in trunk mode
- it appears you can get around this
router#conf t router(config)#int fa0.2 router(config-subif)#ip helper-address address_of_server router(config-subif)#end
- 8266 with Arduino Wi-Fi library seem happiest with `encryption mode ciphers aes-ccm`
Unanswered Questions
- do we set the channel only with Radio0 or all the “virtual” radios as well?
- do all the ssids have to be on the same channel (guessing yes)
Multiple SSIDs example
config t dot11 ssid LAB2 authentication open authentication key-management wpa ! authentication key-management wpa version 2 wpa-psk ascii testing123 vlan 2 mbssid guest-mode exit int dot11radio0 mbssid encryption vlan 2 mode ciphers aes-ccm tkip ! encryption mode ciphers aes-ccm ssid LAB2 no shut exit interface dot11Radio 0.2 encapsulation dot1Q 2 native exit int fa0.2 encapsulation dot1Q 2 native exit ! -------------------- config t dot11 ssid LAB3 authentication open authentication key-management wpa ! authentication key-management wpa version 2 wpa-psk ascii testing123 vlan 3 mbssid guest-mode exit int dot11radio0 mbssid ! encryption vlan 3 mode ciphers aes-ccm tkip encryption mode ciphers aes-ccm ssid LAB4 no shut exit interface dot11Radio 0.3 encapsulation dot1Q 3 bridge-group 1 exit int fa0.3 encapsulation dot1Q 3 exit ! -------------------- config t dot11 ssid LAB4 authentication open authentication key-management wpa ! authentication key-management wpa version 2 wpa-psk ascii testing123 vlan 4 mbssid guest-mode exit int dot11radio0 mbssid ! encryption vlan 4 mode ciphers aes-ccm tkip encryption mode ciphers aes-ccm ssid LAB4 no shut exit interface dot11Radio 0.4 encapsulation dot1Q 4 bridge-group 1 exit int fa0.4 encapsulation dot1Q 4 exit
note: see comment about vlans and switchports above. That configuration for the fastethernet *may* be required
References
- https://docs.google.com/document/d/1NgABdg-aOfQ045B2q-Q9nhHWE-Hz20dadCirKcmSM_0/edit# (original configuration of the access points)