General Information
- serial port is 9600 baud
- to turn something off, put a
noin front of the configuration - to see current configuration
show configuration - you can cut/past multiple commands/settings as once
- see current virtual lans:
show vlan - fastethernet abbreviation is
fa - change hostname:
hostname <HOSTNAME> sshing in:ssh -c 3des-cbc -oKexAlgorithms=+diffie-hellman-group1-sha1 <USERNAME>@<IP-ADDESS>- set the channel only with physical Radio0 and not the “virtual” radios. All the SSIDs will always be on the same channel
- vlans appear to be intended to be used only with Cisco switchports and perhaps when they are in trunk mode
- it appears you can get around this by having the access point forward DHCPDISCOVER broadcast packets directly to our DHCP server using the
ip helper-addresscommand.
router#conf t router(config)#int fa0.2 router(config-subif)#ip helper-address address_of_server router(config-subif)#end
- 8266 with Arduino Wi-Fi library seem happiest with
encryption mode ciphers aes-ccm
Multiple SSIDs example
config t dot11 ssid LAB2 authentication open authentication key-management wpa ! authentication key-management wpa version 2 wpa-psk ascii testing123 vlan 2 mbssid guest-mode exit int dot11radio0 mbssid !channel 2412 !channel 2437 channel 2462 encryption vlan 2 mode ciphers aes-ccm tkip ! encryption vlan 2 mode ciphers aes-ccm ssid LAB2 no shut exit interface dot11Radio 0.2 encapsulation dot1Q 2 native exit int fa0.2 encapsulation dot1Q 2 native exit exit ! -------------------- config t dot11 ssid LAB3 authentication open authentication key-management wpa ! authentication key-management wpa version 2 wpa-psk ascii testing123 vlan 3 mbssid guest-mode exit int dot11radio0 mbssid ! encryption vlan 3 mode ciphers aes-ccm tkip encryption vlan 3 mode ciphers aes-ccm ssid LAB3 no shut exit interface dot11Radio 0.3 encapsulation dot1Q 3 bridge-group 1 exit int fa0.3 encapsulation dot1Q 3 exit exit ! -------------------- config t dot11 ssid LAB4 authentication open authentication key-management wpa ! authentication key-management wpa version 2 wpa-psk ascii testing123 vlan 4 mbssid guest-mode exit int dot11radio0 mbssid ! encryption vlan 4 mode ciphers aes-ccm tkip encryption vlan 4 mode ciphers aes-ccm ssid LAB4 no shut exit interface dot11Radio 0.4 encapsulation dot1Q 4 bridge-group 1 exit int fa0.4 encapsulation dot1Q 4 exit exit copy run start
note: see comment about vlans and switchports above. That configuration for the fastethernet may be required
References
- https://docs.google.com/document/d/1NgABdg-aOfQ045B2q-Q9nhHWE-Hz20dadCirKcmSM_0/edit# (original configuration of the access points)